ElecGear 8X FU 10K Trimmer Potentiometer Replacement for PS4, PS3, Switch Pro Wireless Controllers, Trim Pot Resistor Thumbstick Module 3pin Sensor for Favor Union Analog Joystick

Features

• [FU 10K Potentiometer] The OEM trim pot resistor was made by Favor Union (FU). It fits analog joysticks made by FU. This trimmer potentiometer was found in some PS4 DualShock 4 came with PlayStation 4 Pro and some PS3 controllers. FU reported that this orange sensor is also compatible with Nintendo, Hori, PDP, BDA (Power A)
• [Compatibility] FU sensors come in two different resistance values. This 10K version was printed 103. Make sure the value is around 10K ohm before ordering. (Be noticed: Choose 2.3K version for PS5 DualSense and some rare PS4 controllers. The orange potentiometers made by FU do not work with joysticks made by ALPS.)
• [Additional Resistor] Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting
• [For most joystick problem] The potentiometer sensor needs to be replaced when the controller has the problem of creeping, stuttering, a blind spot, a dead spot, a dead zone, or it wouldn't center after years of wear and tear. De-soldering the unit with only 3Pins will be a lot easier than replacing the entire joystick with as many as 14 prongs
• [Reminder of Replacement] Use a pair of pliers to separate the problem sensor off the joystick module. Try to replace the wiper first, see if it works. De-solder the sensor off the PCB. A metal pick helps to clear the holes. Soldering the new unit in is a breeze. Remember to calibrate the new control sticks in settings