Cuttable T-Car Sunroof Cover Seal Rubber Trim,Dust Proof&Weather Stripping for Windshield,Tailgate Adhesive Rubber Seal Strip (30mmx23Ft)

Features

• Upgrade T-Car Weather Strip: Don't put up with the large gap between the front windshield and sunroof causing leakage into dust and the terrible wind noise on the highway The upgraded T-seal strip can perfectly fill the gap between the front windshield,rear windshield, sunroof and frame
• Easy to Install: Thoroughly clean the installation surface; keep the installation environment temperature between 50F - 85F. In case of low temperatures, preheat the sealing strip indoors in advance; to ensure waterproofness, cut the end of the sealing strip at a 45 angle for a tight joint; use the attached adhesive-promoting wet wipes (check the humidity before use) to wipe the installation surface, and press firmly for 30 seconds after installation
• Wide Range of Protection: 30mm*7M T-edge seal strip can be cut upon need for any car small sunroof(3M),panoramic sunroof(7M),both sides of windshield(2M),both sides of rear windshield(2M),etc. Note: The sunroof cannot be opened again after the rubber sealing strip is installed
• Installation Note: The effective temperature range for the product to maintain its adhesiveness is 50F - 85F. Avoid using it in extremely high or low temperatures (below 45F). If it is necessary to use it in extreme temperatures, it is recommended to use it with 3M sealing strip adhesive
• Notes: The thickness of this product is only 3mm/0.12inch, which is relatively thin and not easy to bulge. The width is 30mm. It is recommended that you measure the gap you need to fill before purchasing to avoid incompatibility issues