Nanoprotect Concrete & Stone Sealer Indoor & Outdoor | Long-Term Protection Against Water, Stain & Dirt | for Driveway, Patio, Pavers and Any Absorbent Stone | 1 Gal

Features

• DEEP-PENETRATING PROTECTION FOR CONCRETE & STONE Nanoprotect absorbs deep into the pores of concrete, natural stone, and pavers, providing lasting internal protection instead of a temporary surface layer. Unlike surface sealers that wear off, peel, or flake, Nanoprotect protects your surfaces from within, maintaining durability, strength, and appearance over time.
• REDUCES WATER ABSORPTION & SURFACE STAINING Nanoprotect forms a hydrophobic barrier inside the pore structure of concrete and stone, helping reduce water absorption, dirt buildup, and surface staining. Treated driveways, patios, and pavers stay cleaner longer while maintaining the natural appearance of the surface.
• + 32 MONTH LONG-LASTING PROTECTION Nanoprotect has been tested outdoors for over 32 months under real environmental conditions. Its active protection penetrates below the surface, ensuring that surfaces remain safeguarded even as visible water beading naturally decreases. This long-term protection withstands weather exposure and daily wear while maintaining structural integrity.
• FOR ABSORBENT SURFACES ONLY Suitable for medium to high absorbent surfaces such as concrete, concrete pavers, brick (clay pavers), exposed aggregate, sandstone, travertine, and porous natural stone. Not intended for polished, sealed, painted, or non-absorbent surfaces including marble, granite, porcelain, quartz, or dense stone. Test on a small area before full application.
• EASY SPRAY APPLICATION READY-TO-USE OR CONCENTRATE Clean the surface and allow it to dry before application. Apply evenly with a pump sprayer using a wet-on-wet method for best penetration. Allow approximately 24 hours to dry. Available as Ready-to-Use (1 Gal & 5 Gal) or Concentrate (32 fl oz), which mixes at a 1:11 ratio and yields about 3 gallons of ready-to-use solution.
• COVERAGE DEPENDS ON SURFACE ABSORBENCY Covers up to approx. 200 sq ft per gallon for a single coat application. Wet-on-wet application typically covers around 135 sq ft per gallon, depending on surface absorbency and application method.
• ECO-FRIENDLY WATER-BASED FORMULA Nanoprotect is water-based, ultra-low VOC, solvent-free, acrylic-free, PFAS-free, and microplastic-free. Once fully cured, treated surfaces are safe for households with children and pets while delivering durable protection for indoor and outdoor stone and concrete surfaces.