Poli Glow Mitt Applicator - Apply on Boat and RV Fiberglass Surfaces. Achieve a Smooth and Flawless Surface. (Pack of 3)

Features

• The information below is per-pack only
• The Mitt Applicator was designed to replace the 7 hand-held chamois applicator.
• PREPARATION OF POLI GLOW WITH MITT APPLICATOR: Dampen the Mitt with fresh water, wring out, wrap in a towel and wring out remaining moisture. During application, the Mitt Applicator may have to be rinsed out from time-to-time. Repeat the initial process and resume application. The Mitt Applicator should be damp, not wet. Always wear rubber or plastic, disposable gloves under the Mitt Applicator.
• APPLICATION OF POLI GLOW: Drizzle several lines of Poli Glow onto the palm of the mitt. Mitt Applicator should be moist, not dripping wet. Apply Poli Glow by wiping in one direction (similar to painting varnish) top to bottom or side to side. Do not wipe in a circular motion, instead work in a 4x 6 section. Each coat dries in approximately 1-2 minutes (depending on temperature). Apply a minimum of 6 coats of Poli Glow and move on to the next section.
• MICROFIBER MITT APPLICATOR